Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1143PR-MAINT (Maintenance Processor [TN790 RISC Systems])
10
1131 ABORT INADS port is busy because the system is reporting alarms to INADS, or
because INADS is dialed into the system.
1. If INADS is communicating with the switch the INADS trunk is working.
There is no need to run this test.
2. Or if required. Wait about ten minutes (until the INADS session is
terminated) and then re-enter the command.
1000 ABORT System software resources required for this test are not available.
1. Retry at 1-minute intervals a maximum of 5 times.
1050 ABORT System could not determine if the testing of the INADS port is
administered.
1. Enter the change system-parameters maintenance command. Verify
that the ‘‘Test Remote Access Port?’’ field is set to ‘‘y.’’
2. Retry the command at 1-minute intervals a maximum of 5 times.
2500 Internal system error
2033 Could not send MTP message.
1. Retry at 1-minute intervals a maximum of 5 times.
2000 ABORT MTP did not respond to the test request.
1. Repeat the test at 1-minute intervals a maximum of 5 times.
2. If all MTP tests are aborting, execute the test processor a/b long
command in order to reset MTP and to examine the results of the MTP
Reset Test (#101).
3. Replace the Processor circuit pack.
4. If only the MTP outpulse relay test is aborting, escalate problem.
Table 10-337. TEST #102 MTP Outpulse Relay Test — Continued
Error
Code Test Result Description/ Recommendation
Continued on next page