Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-137display synchronization
8
If the port location is not administered, the following message is displayed:
Identifier not assigned
If the specified port location is out of range, the following message is displayed:
Port/Board location invalid
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear, and then resubmit
Output
For the following output example the command "display port 1c0801" was
entered.
Feature Interactions
None
display synchronization
This command displays the system synchronization administration such as
stratum level (3,4), primary and secondary synchronization reference sources
and DS1 boards.
Port: The port address (cabinet-carrier-slot-circuit) of the specified user
specified port.
Equipment Type: The hardware that is physically connected to the user specified port.
Identification: This depends on the hardware that is physically connected to the
port. If a station is connected to the port the station extension is
displayed, if a trunk is connected to the port a trunk group and
member is displayed, If a modem pool is connected to the port, the
modem pool group is displayed, etc.
display port 1c0801 SPE A
PORT INFORMATION
Port: 01C0801
Equipment Type: Station
Identification: 1021