Lucent Technologies R5SI Computer Hardware User Manual


  Open as PDF
of 2643
 
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1431TIE-DS1 (DS1 Tie Trunk)
10
1003 ABORT The system could not allocate a tone receiver for the
test. The system may be oversized for the number of
tone detectors present or some of the tone detectors
may be out of service. Issue the list measurements
tone-receiver command to display basic information
about the system’s tone receivers.
1. Look for TTR-LEV errors in the error log. If present,
refer to the TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the error log. If present,
refer to the TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at 1 minute
intervals for a maximum of 5 times.
4. If the test continues to abort, escalate the problem.
1004 ABORT The port was seized by a user for a valid call. Use the
display port UUCSSpp command to determine the
trunk group/member number of the port. Use the status
trunk command to determine the service state of the
port. If the service state indicates that the port is in use,
then the port is unavailable for certain tests. You must
wait until the port is idle before retesting.
1. If the port status is idle, retry the command at 1
minute intervals for a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
1020 ABORT The test did not run because of a previously existing
error on the specific port or a more general circuit pack
error.
1. Examine the Error Log for existing errors against this
port or the circuit pack and attempt to diagnose the
already existing error.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Table 10-437. TEST #6 NPE Crosstalk Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page