Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-613DUPINT (Duplication Interface Circuit Pack)
10
Duplication Interface Circuit Pack Invalid
Message Query Test (#272)
The Duplication Interface Circuit Pack Invalid Message Query Test sets the
threshold for the number of bad checksum errors the Duplication Interface circuit
pack detects before reporting the problem to maintenance and queries the
Duplication Interface circuit pack for the number of checksum errors detected.
The error threshold is set to 10. The query causes Duplication Interface circuit
pack firmware to clear its bad checksum error counter. This test is run on both
circuit packs, but has little meaning on Duplication Interface circuit pack B and
should always pass.
Table 10-171. TEST #271 Duplication Interface Circuit Pack
Background Test Query Test
Error
Code
Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
2000 ABORT Response to the test request was not received within the allowable time
period.
2033 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2008
2009
2010
FAIL One or both background tests failed on the Duplication Interface circuit
pack. Error Code 2008 means the ROM test failed. Error Code 2009 means
the RAM test failed. Error Code 2010 means both tests failed.
1. Follow the procedures for replacing Common Control circuit packs and
replace the Duplication Interface circuit pack.
2. Rerun the test.
NO
BOARD
The Duplication Interface circuit pack has failed to reply to handshaking
from either the active Maintenance/Tape Processor (in the case of
Duplication Interface circuit pack A) or from Duplication Interface circuit
pack A (in the case of Duplication Interface circuit pack B).
1. Refer to NO BOARD description for the Duplication Interface Circuit
Pack Status Query Test (#315).
Continued on next page