Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-441status conference
8
Endpoint Miscellaneous (EPT MISC) Information. EPT MISC contains
miscellaneous states and counters for an endpoint. The flags can be a value of y
or n. The counters start with initial value of 0x00, they increment to 0xff, and then
56/64 The 65/64 field is derestrict when operating at per-channel
speeds of 64kbps, 128kbps, 192kbps, 256kbps, 320kbps, 384kbps,
512kbps, 768 kbps, 1472kbps, 1536kbps, or 1920kbps; it is
restrict when operating at 56kbps, 112kbps, 168kbps, 224kbps,
280kbps, 336kbps, 448kbps, and 672kbps.
Note that if the conference is configured for Nx56kbs operation, the
endpoint may signal either via capabilities or modes that is operating
at the proper rate. In such a case, even when we receive
derestrict command which does not match the conference
communication mode of restrict, if the capability indicates
restrict (MISC capability has restrict displayed on Page 4) the
STAT 56/64 is set to y to indicate 56/64 compatibility between the
conference and the endpoint.
VIDEO The Video mode: H.261 (recommended), H.CTX (proprietary),
H.CTX+ (proprietary), or SG4 (proprietary) indicate that video is on in
the direction indicated; video-off when the video is off.
MLP Multi Layer Protocol data mode. When Data Mode is administered as
any-mlp or ww-pcs, the MLP mode should be var-MLP. Other
values will affect video status.
The MLP mode should be MLP-off when Data Mode is administered
as none. Again, other values in this mode will affect video status.
H_MLP The High Speed MLP mode. The HMLP mode should be H-MLP-off.
Other values in this mode will affect video status.
LSD Low Speed Data mode. The LSD mode should be LSD-off. Other
values in this mode will affect video status.
HSD High Speed Data mode. The HSD mode should be HSD-off. Other
values in this mode will affect video status.
CRYPT Encryption mode. The CRYPT mode should be encrypt-off. Other
values in this mode will affect video status.
S/M Single/Multi channel interoperability mode. 6B-H0-comp indicates
that the sender is interoperating multiple channels and a single
channel (for example, 6B and H0). Not-comp-6B-H0 indicates that
the sender is not interoperating between 6B and H0. Normally this
value is Not-comp-6B-H0. Other values in this mode will affect video
status.