Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-207BRI-SET, ASAI-ADJ, BRI-DAT
10
1187 ABORT The circuit pack, port or station may have been busied
out by a technician.
1. Look in the Error Log for Error Type 18 (busied out )
for BRI-BD, BRI-PORT, or BRI-SET.
2. If this error type is present for BRI-SET only, then
release the station via the release station
command.
a. If this error type is present for BRI-PORT and
BRI-SET, then release the port via release port
PCSSpp command and run the test again.
b. If the error is present for BRI-BD, BRI-PORT, and
BRI-SET, then release the circuit pack via the
release port PCSSpp command and run the test
again. If the error is present for both BRI-BD and
BRI-PORT, then release the circuit pack via the
release board PPCSS command and run the test
again. If the error is present for BRI-SET only,
then release the circuit pack via the release port
PPCSS command and run the test again.
NOTE:
When you release the circuit pack, you
release all ports associated with it. If
certain ports still need to be busied out,
use the release port PCSSpp
command to busy them out.
3. Make sure the terminal is connected.
4. Retry the command at one-minute intervals a
maximum of five times.
5. If the test continues to abort, escalate the problem.
2012 ABORT Internal System Error.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Table 10-67. TEST #627 BRI Remote Loop Back — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page