Filter
Top Products
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-73clear audits
8
Description
This command is used to clear the cumulative and/or peak hour’s data that has
been collected for each data relation audit. The purpose of this command is to
clear old data so that when the "status audits" command is used only data
collected since the last "clear audits" command is displayed. With this command,
the user can clear the peak hour’s data that has been collected or both the peak
hour and cumulative data (refer to the "status audits" manual page for more
information).
Defaults
None
Parameters
Help Messages
If the technician presses HELP after entering "clear audits" the following message
will be displayed:
peak-hour cumulative
Error Messages
If during the execution of a command a resource problem occurs that requires
the user to restart the command, then the following message will be displayed:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
Output
If the clear audits command is successful, the following message will be
displayed on the SAT:
Command successfully completed
If the clear audits command is unsuccessful, the following message will be
displayed on the SAT:
cumulative This option will cause the data collected since the last reboot or "clear
audits cumulative" command and the data collected about the peak
hour to be cleared.
peak-hour This option will cause the data collected about the peak hour to be
cleared.