Filter
Top Products
Management Terminals
Page 3-1General
3
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
3
3
Management Terminals
General
Maintenance personnel can use the management terminal to initiate the same
tests that the system initiates. Test results display on the terminal screen. This
chapter illustrates these terminals, explains how to use them, and identifies the
typical maintenance tasks that can be performed from them.
Management Terminals
The maintenance interface for the system technician is the management terminal.
These terminals may be referred to as an
administration terminal
.
The following terminals are supported as administration terminals:
■ 715 BCS
■ 2900/715 BCS
■ 715 BCS-2
In a standard reliability system, the terminal connects to the Processor circuit
pack. In the PPN of a high or critical reliability system , the administration terminal
connects to the Duplication Interface circuit pack in the PPN. In the EPN of a
standard reliability system or of a high or critical reliability system, the
administration terminal connects to the Maintenance circuit pack in the EPN.
Duplication Interface circuit pack A controls and monitors the same environment
leads as the Maintenance/Tape Processor in a PPN system without high or
critical reliability. Duplication Interface circuit pack A also supports the serial
channel to the terminal in a PPN for a high or critical reliability system. The
terminal connects to Duplication Interface circuit pack A via a connector, labeled